Why is the MotoBrush not as useful?

First of all, what is a MotoBrush ? A MotoBrush is pretty much a portable vaccum device that contains a hose and a brush on the end of it.

Their are many reasons why the MotoBrush is not as useful as using an Air Compresser attached to an airwhip or Airhose ect.. One reason why is that it will not extend as far as a three hundred foot hose will.One of  the reasons it is so nice to have a very long Air Hose is so that you can reach the furthest areas in the Air Ducts and you won’t need to worry about not reaching the Trunk Line down below.

Another reason it is nice to have an Air Compresser hose with an Airwhip on the end of it is because you have a Whip  on  the end of the Air Hose that will slap  around and then it will  loosen up every peace of gunk  therfore you do not need to suck it all out of the vents upstairs with a vaccuum because you already have a vaccuum hooked up to the furnace so all of the garbage gets put into the Trunk Line and then  you  go into the crawlspace with the Airwhip and blow it all into the furnace and then it gets sucked into the vaccum into the truck, on the other hand with a MotoBrush you need to carefully  carry the machine around the house with you, therfore the prosses is a lot slower.

Sometimes in an Airduct System there will be gunk that is caked onto the Duct work and may be very hard to get off, in that case the Motobrush may clean all around the gunk but it will skip over whatever  may be stuck inside of the Duct, that is why the Airwhip comes in handy because it whips evrything instead of just  brushing it.

Using the Motobrush is useful therefore it will make the process of cleaning your Ducts a lot longer because you may need to spend a lot  longer of a time trying to get all of the stuff loose. Another advantage of using the Air Hoses is they have a smooth surface and they are very skinny in width, that will make it a lot easier for the person cleaning to slide the hoses down into the vents perhaps if the ducts have curves in them you won’t need to use all your might to push the hose down the ducts.

In my personal oppinion I will never switch from using the Air Compresser hoses, Air Whips , and the Airhoses to using the Motobrush because I know that if I did that I would be going a lot slower and probrobly not doing as thorough of a job as I was doing before, that is probrobly not a good thing when it already takes you about three or three and a half  hours or mabe even longer if it is a two or three story house otherwise, especialy if you have a couple more Duct jobs afterwords.

So What I am trying to say is that I would personaly recomend using an Aircompresser Hose and a ten inch wide vaccuum hose than using a very small Motobrush, only because it will leave you with cleaner Ducts.